Wire Builder Interface Description

1. Wires Tab

Tab to enter the Wire Creator panel

2. Create Wire

Create a new wire in the scene

3. Title

Input field to type in the name of the wire.

4. Wire start point

Dropdown to select the starting point of the wire. The wire will start from the center of the selected object.

5. Wire endpoint

Dropdown to select the ending point of the wire. The wire will end at the center of the selected object.

6. Color

Input fields to type in the RGB value of a color. The values go from 0.0 - 1.0. The square below the fields visually shows a preview of the color.

7. Width

Input fields to type in the width of the wire.

8. Local Start Position

Input fields to specify the starting position of the wire, relative to the center of the wire start point. If you don’t want the wire to start at the center point of the wire start point, you can shift the start position using these fields.

9. Local End Position

Input fields to specify the ending position of the wire, relative to the center of the wire end point. If you don’t want the wire to end at the center point of the wire end point, you can shift the ending position using these fields.